Most of the cards I have seen done with this card have been ones that you color in which come out beautiful but I needed a quick card for a swap that I was doing with my team so I created this one.
This card is quick and easy:
Here are the instuctions, card cuts and supply list:
Card Base - Basic Black - 5 1/2 x 8 1/2 scored at 4 1/4
Layer 1 - Brushed Metallic CS - 4 x 5 1/4
Layer 2 - Basic Black - 4 1/4 x 5 1/2
Layer 3 - Basic Black - 5/8 x 2 3/4
Layer 4 - Brushed Metallic CS - 3/4 x 3
Layer 5 - Basic White - 4 x 5 1/4
Instructions:
1. On card front rub with embossing buddy then using versa mark ink stamp the image onto the center of the card front.
2. Cover with Gold Embossing Powder.
- Flick off excess powder
- Then heat up with heat tool.
3. Layer 1 - Using the Layering Diorama dies cut center using a smaller die then you will use in the next step and large enough that you will see the image you just stamped.
- Using dimensionals pop this up onto the card front.
4. Layer 2 - Using the Layering Diorama dies cut center using a larger die then the one you used in Layer 1.
- Brush with embossing buddy
- Using Versa Mark ink stamp the flower pots and ferns as shown in each corner
- Cover with gold embossing powder
- Flick off excess powder
- Heat with heat tool
- Adhere to the card front over Layer 1.
5. Layer 3 - Using versa mark stamp the sentiment onto center.
- Cover with gold embossing powder
- Flick off excess powder
- Heat with heat tool
- Adhere to layer 4.
6. Layer 4 - After you have added layer 3 then adhere to card front as shown.
7. Layer 5 - Using crumb cake ink stamp pots in the lower right hand corner.
- Stamp sentiment as shown
- Adhere to the inside of the card.
Supply list: Note (The only way to get the stamp set is to make a $50 purchase 3 August - 30 September 2021) if you buy some of the other items on this list you will quality to get this set for free!.
No comments:
Post a Comment