Julie's Creative Stamping: Tasteful Touches and the In Good Taste Suite "Hello" card!

Welcome to my blog! Today's card is made using products from the In Good Taste Suite by Stampin Up!®. The nice thing about these suites is that you can buy it all at once or just the bits and pieces that you like from each suite. I find that I do combine elements from other suites at times. Like this card I brought in the ribbon pack from the Flowers for Every Season suite. Some elements help to add texture to cards like the In Good Taste wooden elements from this suite. You can also add texture by using Stampin Dimensionals. Have fun and experiment with textures when your creating your cards. You'll surprise yourself when you see your end project! Hope you enjoy this card.

Here's a video link with this card and 2 others using this suite!

https://www.facebook.com/StampinJulieBrown/videos/3154089274651111

I'm also including written instructions.

Project Instructions:

Cuts and Card Base. DSP = Designer Series Paper

Card Base - Thick Whisper White - 5 1/2 x 8 1/2 scored at 4 1/4

Layer 1 - In Good Taste DSP - 4 x 5 1/4 cut into 2 pieces (One 2 1/4 x 4 and One 3 x 4)

Layer 2 - Night of Navy - (2) 1 x 3

Layer 3 - Whisper White - 1/2 x 4

Layer 4 - In Good Taste Wood Element

Layer 5 - Whisper White - 4 x 5 1/4

Layer 6 - Night of Navy - 4 x 5 1/4

Layer 7 - Whisper White - 3 3/4 x 5

1. Layer 1 - Adhere one of the Night of Navy strips (Layer 2) to the the 3 x 4 sheet (Slate) about 1/2" from left edge and flush with the top.

Then wrap ribbon around the top and hang down to about 1/2' from bottom edge of Night of Navy strip.

Adhere the 3 x 4 sheet (Slate) on the top of the card leaving space at the top and side edges.

Then adhere the 2 1/4 x 4 sheet (Brick) right below the top one again leaving space at the bottom and side edges.

Adhere the other Night of Navy strip to the Brick sheet on the right side centering top and bottom and flush to the right edge.

2. Layer 3 - Stamp the flourish image in Night of Navy Ink onto this strip then adhere to the card front layering over the top and bottom sheets covering where they meet.

3. Layer 4 - Using a sponge dauber and the Night of Navy ink daub color onto the wood element.

Then adhere to the card front about 3/4" from left side onto the (Brick) DSP. It should layer onto the Night of Navy strip as well.

4. Layer 5 - Stamp the large flower in Night of Navy ink then leaving enough space to cut out with one of the label dies stamp the sentiment in Night of Navy as well.

Cut out sentiment with one of the Label dies. Then fussy cut the flower.

Adhere the Label to the card front on the top section centering top and bottom and overlapping the ribbon and Night of Navy strips.

Color three large rhinestones with the Dark Night of Navy stampin blend then adhere to the label as shown.

Adhere the flower with Stampin Dimensionals overlapping the Wood Element and Night of Navy strip as shown.

5. Layer 6 - Adhere to the inside of the card.

6. Layer 7 - Stamp the flourish image in the lower right hand corner in Night of Navy ink. Then stamp the sentiment in Night of Navy in the center of the sheet.

Adhere to the inside of the card .

Don't forget to get all the supplies you need to recreate these cards.

tams# 49239

Product List