Flowering Blooms Card 3 "Birthday Card"

Here's my last card in the Flowering Blooms series.  This one I went all out using the Dies, Designer Series paper and bringing in another Die set!  This card has a lot of texture and elements but it still goes together quickly!  I'm a fan of the easy button and I get excited about cards that look complicated but are easy to put together!  I hope you have enjoyed my Flowering Bloom series and that it has given you some inspiration to make your own cards!

Here's the video with all three of cards in this series!

https://www.facebook.com/StampinJulieBrown/videos/606992956675219

This card starts at the 42:38 mark!

Instructions:

Cuts and Card Base - DSP = Designer Series Paper

Card Base - Pretty Peacock - 5 1/2 x 8 1/2 scored at 4 1/4

Layer 1 - Forever Greenery DSP - 4 x 5 1/4

Layer 2 - Soft Sea Foam - 1 x 5 1/2

Layer 3 - Whisper White - 2 1/2 x 5 1/4

Layer 4 - Pretty Peacock - 2 1/4 x 3 1/2

Layer 5 - Whisper White - 3 x 4

Layer 6 - Vellum - 2 1/4 x 3 1/2

Layer 7 - Whisper White - 4 x 5 1/4

Instructions:

Layer 1 - Adhere to the card front.

Layer 2 - Stamp sentiment in Black Memento ink on the right side. 

A.  Adhere to the card front centering top to bottom.

Layer 3 - Adhere a piece of adhesive strip to the back then

A.  Using the border Die from the "Flowering Dies" cut out 2 borders.

Note: it will not reach to the edge so you will have to add the die to the end of each one and continue cutting to get one continuous border.  (See Video for correct placement)

B.  Adhere to the card front flush against Layer 2, one on the top and one on the bottom!

Layer 4 - Cut out using the Ornate Layer Dies.

A.  Adhere to the card front using Dimensionals onto Layer 2 on the left side about 1/8" from left edge.

Layer 5 - Stamp the smaller flower and the flower on the vine in Rococo Rose ink.

A.  Stamp 2 leaves in Shaded Spruce ink.

B.  Cut out with Dies and trim down. 

Layer 6 - Cut out 2 of the leaves with the "Flowering Dies"

Arrange the flowers and leaves onto Layer 4 using mini glue dots as desired.  Using the Dark Pretty Peacock Stampin Blend color in three Basic Rhinestones then add to card front as shown.

Layer 7 - Stamp the flower image and leaves in the bottom right corner.

A.  Stamp sentiment in Black Memento ink.

B.  Adhere to the inside of the card. 

If your are enjoying my cards, enter you email to the right under the "Follow Me" section then hit submit and you receive an email each time I post a new card to my Blog!

Don't forget to order your supplies by click on the photo's below!

tams# 50469

Product List

154120

152726

152492

150880

100730

101856

150080

147088

132708

154895

144220

104430

152813

103683

147042

152334

 

 

  

 

 

 

 

 

Flowering Blooms Card 2 "Thank You"

Here's my second card in the Flowering Blooms series.  This time I used the Flowering Dies and some Designer Series Paper to give this card a little step up.  These are not the normal colors that I would think to put together but took a leap of faith and was pleasantly surprised with the outcome!  Let me know what you think about these color combinations in the comments below!  I used Crushed Curry, Calypso Coral and Purple Posey! 

If you want to get an email with the newest cards I post to this blog just plug in your email to the right and hit submit!
 

https://www.facebook.com/StampinJulieBrown/videos/606992956675219

Video for this card starts at the 15:17 marker.

Instructions:

Cuts and Card Base. DSP = Designer Series Paper

Card Base - Crushed Curry - 5 1/2 x 8 1/2 scored at 4 1/4

Layer 1 - Whisper White - 4 x 5 1/4

Layer 2 - Playing with Pattern DSP - 1 x 5 1/2 

Layer 3 - Purple Posy - 3/4 x 5

Layer 4 - Calypso Coral - 1 x 5

Layer 5 - Crushed Curry - 2 1/4 x 4 1/4

Layer 6 - Whisper White - 2 3/8 x 4

Layer 7 - Calypso Coral - 3/4 x 4 1/4 

Layer 8 - Purple Posy - 4 1/8 x 5 3/8

Layer 9 - Whisper White - 4 x 5 1/4

Instructions:

Layer 1 - Adhere to the card front

Layer 2 - Adhere to Card front about 3/8" from left edge. 

Layer 3 - Adhere to the card front flush against Layer 2 and about 1/4" from top edge.

Layer 4 - Adhere an adhesive strip to the back of sheet then: 

A.  Using the Border die from the Flowering Dies run through die cutting machine.

B.   Adhere to card front centering over Layers 2 & 3 about 1/2" from left edge and 5/8" from top edge.

Layer 5 - Adhere to the card front flush against Layer 4.

Layer 6 - Using Purple Posy ink stamp the large flower image onto sheet.

A.  Then adhere to the card front onto Layer 5 keeping left edges flush.

Layer 7 - Stamp sentiment in Black Memento Ink.

A.  Adhere to card front about 3/4" from bottom edge using Stampin Dimensionals.

Adhere three of the Purple Posy Playing with Patterns Resin Dots as shown. 

Layer 8 - Adhere to the inside of the card.

Layer 9 - Using Calypso Coral ink stamp the "Flowers on a Vine" on the right side of the sheet.

A.  Then stamp the sentiment in Black Memento ink.

B.  Adhere to Layer 8 on the inside of the card. 

If you'd like to purchase and of the supplies needed to make this card just click on the photo's below!  

tams# 50464

Product List

154120

152490

131199

100730

122925

150881

150084

147101

132708

152467

152334

104430

152813

 

 

 

 

 

 

Flowering Blooms "Simple Stamping"

Thanks for visiting my Blog today!  This is my first in the Flowering Blooms Series.  Another great Bundle by Stampin Up®.  This first card is a simple stamping card!  This is one of the distinktive stamp sets in the catalog! These stamp sets are perfect for simple stamping because the way they are made naturally puts the shading in the image. I did use a masking technique on this card using a post it note.  This is done by Stamping the image onto a post it note then cutting it out and placing it over a stamped image and layering other images onto the page.  It's an easy way to layer several stamps on top of each other without damaging the original stamped image. 

Here's a video showing how I made this card and the masking technique.  There are 2 other cards in this video as well. 

https://www.facebook.com/StampinJulieBrown/videos/606992956675219

Instructions:

Cuts and Card Base

Card Base - Basic Black - 5 1/2 x 8 1/2 scored at 4 1/4 

Layer 1 - Whisper White - 4 x 5 1/4

Layer 2 - Whisper White - 4 x 5 1/4

Instructions:

Layer 1 - Stamp the flower image onto a post it note then cut out and set aside

A.  Using Flirty Flamingo Ink stamp the large flower image onto Layer 1 towards the bottom right of the sheet. (Try to keep as much of the flower onto the sheet as possible)

B.  Then stamp the image towards the bottom left side stamping off the page. 

C.  Next using the Flowers on the vine image.  Stamp between the 2 flower images, stamping off the bottom of the sheet.

D.  Cover the large flower image on the right with the Stamped image on the post it note.  Then stamp 2 more "Flowers on the vine" images as shown. Note: The post it note will protect the original stamped image. 

E.  Using Black Memento Ink stamp the sentiment at an angle as shown.  

F.  Adhere to the card front. 

Layer 2 - Stamp the "Flowers on the Vine" image along the right side of the sheet (top to bottom)

A.  Using Black Memento Ink stamp the sentiment onto the center of the sheet.  

B.  Adhere to the inside of the card. 

One great thing about Simple Stamping is that is doesn't take a lot of products to make.  This card was made with a Card base, two Whisper White sheets, Flirty Flaming Ink, Black Memento Ink and a Post it Note.  I hope you like this card.  Please leave me a comment below to let me know what you think!

If you want to receive a notice each time a post a new card just type in your email to the right under "Follow me" and hit submit.  Then you will receive an email with my newest cards posted to this blog!

Don't forget if you need to purchase any supplies to make this card just click on the pictures below!

tams# 50462

Product List

152575

121045

100730

147052

132708

152813

 

 

 

 

 

 

 

Hippo Happiness "Friendship"

This is my last card in the Hippo Happiness series!  I've had such a fun time creating cards with this wonderful Bundle.  If you've missed the other cards look for them here in my blog!  I love butterflies so this card way a joy to make!  I know that we are entering fall right now but I still wanted to share a little bit of summer!.  For this card I used the Hippo Happiness Bundle along with the 2020-2022 In-Color Designer Series Paper all from Stampin UP®.  

Don't forget to submit your email to the right so that you will be notified by email when I add a new post to this blog!

Here's a video link with this card and the other 2 cards that I did with this Bundle! This card starts at the 47:17 mark. 

https://www.facebook.com/StampinJulieBrown/videos/694504031100547

Instructions:

Card Base and Cuts - DSP = Designer Series Paper

Card Base - Thick Whisper White - 5 1/2 x 8 1/2 scored at 4 1/4

Layer 1 - Bumblebee - 4 1/8 x 5 3/8

Layer 2 - 2020-2022 In-color DSP - 4 x 5 1/4 (Misty Moonlight Polka dot)

Layer 3 - 2020-2022 In-color DSP - 4 x 5 1/4 (Bumble Bee -Back of Polka dot)

Layer 4 - Whisper White - 1 1/2 x 4 1/4 (butterflies)

Layer 5 - Whisper White - 1 1/2 x 4 1/4 (sentiment)

Layer 6 - Misty Moonlight - 4 1/8 x 5 3/8

Layer 7 - Whisper White - 4 x 5 1/4

1.  Layer 1 - Adhere to the card front.

2.  Layer 2 - Adhere to Layer 1 on the card front.

3.  Layer 3 - Cut out three shapes with the Hippo & Friends dies.  Set aside.

Note: I used the smallest of the more rounded dies.

4.   Layer 4 - Stamp three of the butterflies in Misty Moonlight/Seaside Spray ink. 

A.  Cut out with the Hippo & Friends dies. 

B.  Adhere one butterfly to each of the Label dies (Layer 3) you just cut out.

C.  Then stamp the swirl image onto each label.

D.  Adhere to Layer 2 on the card front.

1. I popped up the top label and used liquid glue to adhere the two lower labels.

Note: leave space between the lower labels to add the sentiment label.  

5.  Layer 5 - Stamp the sentiment (Well Said stamp set) in Misty Moonlight ink. 

A.  Cut out with the smallest oval shaped label die. 

B  Adhere to the card front between the bottom labels.  Popping up with dimensionals.  

Add five of the basic pearls to the card front as shown.

6.  Layer 6 - Adhere to the inside of the card.

7.  Layer 7 - Stamp a butterfly Misty Moonlight/Seaside Spray in the bottom of the right hand corner.  

A. Then stamp the sentiment (Well Said stamp set) in Misty Moonlight ink as shown. 

B.  Adhere to inside of the card onto layer 6. 

I hope you have been inspired by the Hippo Happiness series!  Please leave a comment below and let me know what you think! 

Don't forget to get any supplies you may need to make this card by click on the photo's below!

tams# 50327

Product List

154080

153070

140272

153077

100730

153081

153118

150085

144219

104430

152813