This Suite includes the Pansy Patch Bundle (Stamp set and Dies), Pansy Petals Designer Series Paper and Bumblebee Trinkets.
I also used the Brick & Mortar 3D embossing folder. Hopefully you can see that I did pop up two of the pansies on the top with Stampin Dimensionals. To finish off the card front I added Basic Pearls to the center of the pansies.
Below are the card cuts, instructions and supply list.
If you'd like to know when I post new cards to my blog just add your email to the right under the "Follow Me" section.
Card Cuts: DSP = Designer Series Paper
Card Base - Bermuda Bay - 5 1/2 x 8 1/2 scored at 4 1/4
Layer 1 - Basic Gray - 4 1/8 x 5 3/8
Layer 2 - Basic White - 6 x 6 (Pansies)
Layer 3 - Bermuda Bay - 3/4 x 4
Layer 4 - Basic White - 1/2 x 3 3/4
Layer 5 - Basic White - 4 x 5 1/4
Instructions:
1. Layer 1 - Run through the Die cut machine using the Brick & Mortar 3D embossing folder.
- Adhere to the card front
- 3 - Flirty Flamingo/Melon Mambo
- 2 - Coastal Cabana/Bermuda Bay
- 3 - Daffodil Delight/Crushed Curry
- Note: the lighter color was used for the solid image and the darker was used for the detailed outline.
- Then stamp 6 leaves and 3 stems using Soft Succulent/Evening Evergreen
- Cut them all out using the Pansy Dies.
- Adhere them to the card front as shown. Popping up two of the pansies at the top.
- Place a Basic Pearl into the center of each of the pansies.
- Then adhere to layer 3 on the card front.
- Add a Bumblebee trinket as shown on the left side and a Basic Pearl on the right side.
- Using Daffodil Delight/Crushed Curry, Soft Succulent/Evening Evergreen stamp the Pansy, stem and leaves as shown.
- Adhere to the inside of the card.
No comments:
Post a Comment